Also it’s a 2013 sonata

 

It says B1111 ignition voltage high
Helpppppoo

 

responded to your other post re same issue.
what is battery# you got?

 

Not sure but I do know it’s a diehard battery and it’s pushing out 12v

 

when was stwrter replaced

when was stwrter replaced and who replaced it?

replaced starter yesterday and the battery was replaced mid fall last year

 

when was stwrter replaced and who replaced it?

 

Sorry my cousin owns a auto and towing shop he did it but can’t seem to understand the code and why it’s saying something with the airbag

 

the last sentence on your post there mentions airbag. that why I asked.

like barrendach suggested, get battery load tested.

It seems likely that the new starter is bad or the installation was not done correctly, because that's when the issue started, was after starter was replaced.

were symptoms exactly the same that caused you to replace starter?

 

The car wouldn’t start before the starter was replaced they replaced it because it somehow was burnt up (bad) and thought that replacing it will be what the problem was and it wasn’t they ran the diagnostic and that code B1111 came about

 

The car wouldn’t start before the starter was replaced they replaced it because it somehow was burnt up (bad) and thought that replacing it will be what the problem was and it wasn’t they ran the diagnostic and that code B1111 came about

All the lights were on bright on the dash they tested the battery checked the alternator made sure the engine wasn’t locked up checked the relay and fuse and still nothing

 

You're going for a record here!

 

Test the battery under load...12 volts means little to starting your car.

 

what is "it saying" about the airbag? from your post it seems like you are getting a no start and b1111 that's it. no?

 

It’s not starting at all everything else is working fine I looked up the code and that’s what it said

 

it's a keyed start or push button?

 

Keyed 2013

 

how long was that fir?
I'd suggest checking either ignition switch or electric power steering module next.

 

Hello everyone yesterday I went to start my car to go to work and it never returned over didn’t make one sound

I wouldn't worry about the airbag trouble code right now. That has nothing to do with why the engine isn't cranking. What I would do at this point is a start relay bypass test :

Make sure the transmission is in P/N.
Remove the START relay from the engine bay fusebox (see below)
Use a length of wire to bridge the two terminals on the relay socket on the fusebox as shown in the diagram.
If the engine cranks you instantly know that the battery, starter and the starter wiring is all good. Meaning the fault is likely to be on the part of the circuit that controls the START relay. Which includes the ignition switch, START fuse (dash fusebox), START inhibitor relay (part of the alarm) and the transmission range switch.

Pushing 12 v when vehicle is running or before you turn ignition on?

The answer to your question is obvious...if you take the time to read the thread 😉

If I helped you fix it, why not...​

Your support is greatly appreciated​