there's a section in the mirror install on removing the cover, dunno if it shows what you need:

https://www.hyundaiaccessories.com/admin_media_uploads/installationSheets/abf62au000.pdf?cts=20210414094230

 

Thank you for the help, that doesn't show the part I need to remove however

For some context I have attached pictures:

I was able to remove the first two plastic trim pieces (just snap on, no screws) but I am unsure of how to continue removing the rest of the unit.

 

OP.... you ever figure this out? I am in the same position and cannot get this console down for the life of me.

 

Never mind OP, I got it. Once in a while, you just gotta pull!

There are two clips where the screws usually are (circles), and 4 clips that hold it to the headliner (arrows)... 2 on the bottom one on each side. The top just rests on the headliner. I use a hook tool in the map light cavities to pull down and release the clips. Then I used a plastic pry tool to release the clips from the headliner.

 

This is perfect. Now to check those wires in the mate-n-loc connectors. Thank you, thank you, thank you!

 

Dealing w this right now

 

Went to put leds in and my snap bulb connector popped into the back. I had to pry from the rear view side till I got my fingers in and then popped the whole unit as OP suggested. thank goodness I was a little angry for a bit

 

Is there any chance you can make a video of how to do it. I did the same thing and despite reading all of this I can’t figure out how to remove it.

 

The clips holding the headliner don’t seem very sturdy, one of the clips seems as if it’s bending/breaking for me

 

It’s there a video??