Hyundai Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I've got a project. The short story, my timing belt is shot and the valves hit the piston heads - not good.

Ok, i'm busy pulling the motor apart and I'm stuck trying to get the bolts loose to remove the valves.

They look like they are a "reverse torque" but I had no luck at the auto parts store ....
First: trying to get the right tool. The guy keeps saying it is a 13m. It is not. Anybody know for sure?

Second: After I eventually remove the valves, what holds the spring onto the valves?
(i can probably figure this out once it's out but tips welcome)

Third: When I reassemble the parts, how do you determine what is Top Dead Center of the Compression stroke of the 1st cylinder?

Ok, pencil read to take notes.

Thanks in advance.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top