Hyundai Forums banner
1 - 1 of 3 Posts

· Registered
12 Posts
Discussion Starter · #1 ·
I am looking at the pictures shown in the hmaservice site. However, the pictures and instructions are not very clear on what is needed to slide out the corner tail/brake lights.

Basically, the instruction is to remove the 2 screws and then remove the connector that is powering the lights.

No where does it indicate that you have to push on a tab or something to remove the lights.

I yanked and yanked and tugged and tugged but to no avail. I thought I was going to snap the light that is how hard I pulled on it with what grip I can get on it.

Could some one please lend your experience on this matter?

I really hate to go back to the dealer on a simple bulb change that they will charge me 1/2 hour labour to do what I would take 5 minutes to do if I know how the fixture are held on.

1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.