Hyundai Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
136 Posts
Question: what type of ballasts do you use for you HIDs?

I ask this because I had the same issue, albeit a lot sooner than you did. I had the standard size ballasts and I noticed that my HIDs would flicker a bit before turning on, even with the fuse relay hooked up to the battery.

Then one day I was going under an underpass and ran into traffic. The car detected darkness and turned on the HIDs and bam, the car stalls right there on the interstate. I'd also had the same issue with flashing my high beams and the car stalling.

Once I switched both of my ballasts to slim ballasts, all of these issues went away (at least it been a couple months so far, but they seem to preform a lot better than the standard size ballasts).
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top