Hyundai Forums banner
1 - 1 of 1 Posts

16 Posts
Discussion Starter · #1 ·
Further to my recent engine replacement. The car is running fine now - except very occasionally following startup it will not pull and appears to go into limp mode. This only happens from start up i.e goes not happen once car has been running for a few minutes. If I pull over switch off engine and start up again every thing is OK. I have a maxiscan code reader and there are no stored codes (and no engine management light). Any thoughts people?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.