Hyundai Forums banner
1 - 6 of 6 Posts

· Registered
Joined
·
54 Posts
Discussion Starter · #1 ·
Hi! I have a 2010 accent hatch and I want to use the lower center dash tray to mount a scan gauge.

i want to pull out that tray/storage bin thing right above the power/cig lighters and drill hole through the side of the drawer to run a cable back to the obdII port. How does that tray come out? I see no screws and have tried to push in on the sides of the drawer while pulling outward but no dice...

the service manual says to disconnect the tray. How??

In the pic below, i am talking about that storage tray that swings out.

thanks!!!

http://i908.photobucket.com/albums/ac282/bzavetsky/dash.jpg
 

· Registered
Joined
·
54 Posts
Discussion Starter · #7 ·
got it!!!

now when i get that out i see the screw. if i remove that screw can i then remove the whole thing so i can get a wire to the rear right near that screw? i wish to bring in my scangauge ii wire so as to mount it in the tray. need place for it. if you don't know, don't woory. i will try this weekend sometime to see what's behind there..

thanks!
 

· Registered
Joined
·
54 Posts
Discussion Starter · #9 ·
well i can't get that lower center fascia off. i tried prying but she won't come all the way out. I knicked the edge up a little but barely noticeable. I will try again tomorrow. If I can get that fascia out i can see if i have a place to run the wire. if i do, i will drill a hole for the scangauge wire. will be most cool.

anybody have any luck getting that fascia off?? if so, how??
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top