Thank you for your pictures and response.
I did not know it was fastened with one bolt.
I moved the carpet out of the way further by removing the left panel under the hood release, and I could see the bolt.
I removed the bolt and slid the broken part out.
I'm now just using the remaining part of the leaver as a pull cord as I can't see replacing the part a good idea, and it also seems that it would be a next to impossible job re attaching the cable in the small area in which the part resides.
Thank you once again, now I won't have people bugging me about my gas door being open.
Hey guys. I recently bought Hyundai Venue DCT SX+. I have noticed something unusual. Whenever i am in traffic, transmission temperature starts rising and it goes to Very high in just 10-15 minutes of traffic. When it gets too hot, unusual odour comes and an alarm triggers saying Transmission...
My left front light unit does not work, no low beam, now high beam no flasher, just dead.
Does anyone have a wiring diagram for the headlights? Or have some hints where to start looking, fuse or relais.
Lightbulbs are good, already switched with right side. Was rhis afternoon at my Hyundai...
I just recently installed a Pierce hf downpipe
Added o2 angled spacer
The two main codes are the p2270 and p2196 they both point two voltage reading but unsure if it's cause the wires pinch by zip tie to keep them from the heat or the o2 sensors got reversed during install.
I have a small leak...
This is a link to a site where you can download the SERVICE MANUAL (ITALIAN) and ONERS MANUAL (ENGLISH)
Paste it into your browser and you will be directed to my TERMINAL where you can download the manuals
Below is the email address of...