[Billy2423]

After about 10 to 20 mins either driving or idle the engine stops and will not start again for afew hours or so. What could be the cause?

Thanks for u'r help in advance.
Bill

 

[Billy2423]

Thanks for the reply. I see if I can get a diagnostic code reader and go from there.

 

[Billy2423]

Yes, Auto Zone is the closes one around here, but still need to get the car to them. Thanks

 

[Billy2423]

I bought a INNOVA 3100e OBDll and this is the code PO722 = output shaft speed sensor-no signal.

now i am lost as different auto stores are listing different sensors as there is not the one above but u have to just put in speed sensor.
http://www.thepartsbin.com/catalog/?D=shaf...ft+speed+sensor that is the only place i found that says output shaft speed sensor.

So is this what i need? Thanks again for the help.

 

[Billy2423]

I could not find that part on the car. Bought from dealer the Generator Pulse assy #45955 22701 and installed that but still shuts off. Anymore help. Thank U

 

[Billy2423]

Thanks. I knew the it needs reprogramed. I will check pins 3 & 4. But still need to get the car to run so I can get it to a dealer to have TCM reprogramed. Maybe replace the crank sensor too, to see if it will run. Winter here now, so not sure when i will get back to it.