Hyundai Forums banner

1 - 20 of 31 Posts

·
Registered
Joined
·
505 Posts
Discussion Starter #1
Well, wifey (who is hard on cars) decided to break the cup holder of all things.

The little flip down/up thing that is used for smaller (cans) beverages...

Do you think this would be a warranty item?

Anyone know of an aftermarket replacement? I have searched and have not found anything...

Thanks..
 

·
Registered
Joined
·
3,712 Posts
Mine broke a week or so ago. The only thing I see is a center console replacement. I'm not sure what can be used as a replacement. Let me know if you come up with something that works. I'm out of 5/60.
 

·
Premium Member
Joined
·
4,858 Posts
QUOTE (Klute @ Jul 19 2010, 07:14 AM) index.php?act=findpost&pid=342862
Well, wifey (who is hard on cars) decided to break the cup holder of all things.

The little flip down/up thing that is used for smaller (cans) beverages...

Do you think this would be a warranty item?

Anyone know of an aftermarket replacement? I have searched and have not found anything...

Thanks..

They fixed my arm rest latch I broke years ago so if you have a nice service guy and ask them to do it when your in for something else I am sure they will. If not get the part from a junk yard
 

·
Registered
Joined
·
505 Posts
Discussion Starter #4
QUOTE (craigbrooks @ Jul 19 2010, 10:02 AM) index.php?act=findpost&pid=342872
Mine broke a week or so ago. The only thing I see is a center console replacement. I'm not sure what can be used as a replacement. Let me know if you come up with something that works. I'm out of 5/60.

I'm still under the 5/60,. maybe that will work, huh?
 

·
Registered
Joined
·
2,204 Posts
The flip-up thingie came off mine a while back. It wasn't too difficult to replace, but it pops into the lid, which I don't think can be replaced. Do they make extra thick koozies? It may be possible to make something that takes up the extra space.
 

·
Registered
Joined
·
505 Posts
Discussion Starter #8
QUOTE (Dennis the Mennis @ Jul 21 2010, 01:46 AM) index.php?act=findpost&pid=343480
The flip-up thingie came off mine a while back. It wasn't too difficult to replace, but it pops into the lid, which I don't think can be replaced. Do they make extra thick koozies? It may be possible to make something that takes up the extra space.

Yes, thought about the fat koozie option....that 'Busch' Beer koozie from high school would work great! LOL...
 

·
Banned
Joined
·
12 Posts
This item was subject to a FEDERAL RECALL. All Veteran Forum members should have known this :whistling:

Body, Interior & Misc.: EQUIPMENT
Service Bulletin Number: 501016
NHTSA Number: 10019156
Model Years Affected: 2006
Date of Bulletin: 02/2006
Bulletin Summary: REPLACEMENT OF FRONT CUP HOLDER RUBBER FLAP (CAMPAIGN T18).
 

·
Registered
Joined
·
17,552 Posts
QUOTE (Buddy Hitler @ Jul 22 2010, 04:40 PM) index.php?act=findpost&pid=343955
This item was subject to a FEDERAL RECALL. All Veteran Forum members should have known this :whistling:

Body, Interior & Misc.: EQUIPMENT
Service Bulletin Number: 501016
NHTSA Number: 10019156
Model Years Affected: 2006
Date of Bulletin: 02/2006
Bulletin Summary: REPLACEMENT OF FRONT CUP HOLDER RUBBER FLAP (CAMPAIGN T18).



Did a bunch of them on the first couple month production NF back in 2006.... it is the rubber flap..... fella has 2007 and says the fold down divider is broke... rubber flap recall not applicable to 2007 NF.

When the divider breaks, you have to replace the whole cup holder module in the console.. did 1 here a couple week ago, pretty simple, just remove the section of top console with the cup holder, and replace the holder (4 screws on underside)..
 

·
Registered
Joined
·
363 Posts
Where are these screws?

Mine broke a couple months ago, out of warranty of course.
I thought the part was about $80.

Anyway, there is an old thread here about drilling a hole in the fold down part and use a nail as a replacement pin. Which I haven't done.
 

·
Registered
Joined
·
17,552 Posts
QUOTE (Suzanna @ Jul 25 2010, 08:33 PM) index.php?act=findpost&pid=344700
Where are these screws?
The module is held to the underside of the console panel with 4 screws... If you have new cup holder ready to install, open center console lid, open the cup holder lid, grab cup holder lid and give it a carefull tug upward to pull the console panel loose.. there is 6 clips I think it is, as it comes loose, you'll see how the panel comes up & off.

Mine broke a couple months ago, out of warranty of course.

I thought the part was about $80.
Could be.. I think I put one a week or so ago, think it was like $95 installed

Anyway, there is an old thread here about drilling a hole in the fold down part and use a nail as a replacement pin. Which I haven't done.
 

·
Registered
Joined
·
17,552 Posts
QUOTE (Suzanna @ Jul 26 2010, 09:46 AM) index.php?act=findpost&pid=344824
New cup holder? Transmission flush?
Cup holder? Transmission?
Tough decisions.

Transmission, you need it to keep the car mobile...

Drink holder... all you gonna do is spill drinks and foul wiring and modules in the consle.. no liquids in the cabin...
 

·
Registered
Joined
·
363 Posts
QUOTE (sbr711 @ Jul 26 2010, 09:54 AM) index.php?act=findpost&pid=344826
Transmission, you need it to keep the car mobile...

Drink holder... all you gonna do is spill drinks and foul wiring and modules in the consle.. no liquids in the cabin...
Yea, yea. I was going to book the transmission flush until the ABS and ESC lights came on an hour ago (see my other thread.)

No liquids in the cabin - without tops. Get real.
I remember my brother once saying no eating in the new car. Of course, his wife and kids listen to him. Never mind how the french fries on the floor got there.
 

·
Registered
Joined
·
17,552 Posts
Did I ever run your VIN for recalls & warranty history ?
 

·
Banned
Joined
·
12 Posts
QUOTE (Suzanna @ Jul 27 2010, 12:24 PM) index.php?act=findpost&pid=345218
I don't know about that. My car is supposidly up to date on all the recalls.
Let sbr711 run your Vin and see if the flip down flap replacement applies to your Unit. He might even be able to see

if the Dealer took care of this already. Plus your extended Service contract might cover it, although it's doubtful! :57:
 
1 - 20 of 31 Posts
Top