Hyundai Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I am replacing the master cylinder in my 2007 Tuscon 2WD. when i go to put the brake pressure sensor on the bottom of the master cylinder and bench bleed the system, i cannot stop brake fluid from seeping out around the seal of the sensor. I have tried a new o-ring and using thread tape. Has anybody had this issue and or have any suggestions to get the sensor tightly sealed onto the master cylinder?
 

·
Registered
Joined
·
5 Posts
Discussion Starter #4
I ended up going to the junk yard and getting another sensor. Sealed immediately, but doesn't look any different than the one I replaced. Autozone wanted $315 for a new one. Junk Yard was $5.70
 
1 - 4 of 4 Posts
Top