Hyundai Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I would like to replace the oxygen sensor on my Australian Hyundai Coupe 1.8Ltr DOHC

(built Nov 96 and from Vin No. it shows as a 1997 Model)

I have an american repair manual so the pics aren't quite the same as the australian model of car that I have
but other than that everything else is OK

Can you please tell me where abouts the oxygen sensor is located (manifold area (engine bay) or exhaust pipe (before/after catalytic convertor))? -

I have read in the manual & some info sites that some model of hyundais have more then one oxygen sensor -does this apply to my car as it is not a early or new model car ( i will cal it a middle model car LOL)?

soo confused - as I thought only one O2 sensor needed changing

Any info/advice is much appreciated
 

·
Registered
Joined
·
3 Posts
Discussion Starter #3
thanx much appreciated for pointing me in the right direction I wasn't quite sure where to post this question
 
1 - 4 of 4 Posts
Top