Hyundai Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I have cylinders 2 4 6 misfiring P300 code and P0022 code.
Does anyone have pictures of the location of the oil control valve for the vvt?
 

·
Registered
Joined
·
17,552 Posts
Clarify which engine, and which OCV.. I have not done any research yet to find if intake or exhaust side..

3.8L Lambda,, intake at Bank 2

In the valley

Mud motor ??
 

·
Registered
Joined
·
3 Posts
Discussion Starter #4
I would like to check the connectors to the OCV, however I would like to know where it is. My 2011 Veracruz has a 3.8l
 

·
Registered
Joined
·
3 Posts
Discussion Starter #5
I am not sure but I think there is only two oil control valves on this 3.8L engine, one for each bank. I think cylinders 2 4 6 are next to the fire wall. However not sure on that either. I can't find any information or pictures anywhere. I have a service manual but does not show anything. All I would like is pictures of there location. Once I get that it will be easy to figure everything out.
 

·
Registered
Joined
·
17,552 Posts
Bank 1 is Bulkhead side of engine (under plenum)

Bank 2 is Radiator side of engine (coils out in open)
 
1 - 6 of 6 Posts
Top