Hyundai Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
448 Posts
Not all impact wrenches do much, most of what you pick up in your local hardware stores won't do anything on a rust seized nut or bolt except make noise. If you can see the threads, you should put some penetrating oil on them.

You mentioned that you see the bolt move, if you're turning it in the clockwise direction, you're tightening it, but you're turning it in the counterclockwise direction and it doesn't come out, you have 2 scenarios (that I can see) - one is that the bolt is stripped, and the other (more likely) is that you have some lock-down nuts or bolts on the tightener assembly. I don't know if this is the case with the Accent, but in general, the lockdown type assemblies have several nuts or bolts that hold the whole assembly tight - the adjustment bolt is only for adjustment and then you tighten the lock down bolts to hold it.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top