Hyundai Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
8 Posts
Model year 2000 does not have captive rotors. If these are the factory-installed rotors, you may have issues removing the philips-head placement screw used to hold the rotors steady during manufacturing. It's perfectly fine to destroy the screws upon removal if you must, since they aren't necessary anyway.

Be sure to check the operation of each caliper, and install good quality brake pads while you are there. The hardest part of this job is raising the car to place it on jack stands to remove the wheel.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top