Hyundai Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hello all,

I have a 2009 Tucson - Canadian 25th Anniversary Edition (link) with a stock Kenwood-Garmin stereo/GPS (model DNR-1000U). Here's an image: link.

The audio and GPS work fine, but the audio display (above the power button) doesn't work at all. (The GPS touchscreen is also a bit wonky, as it locates the position of a touch a bit below where one is actually touching the screen, but I have a separate GPS so I'm not too bothered by this.) If anyone has any info on these issues I'm all ears, but I've read elsewhere that the audio display issue is somewhat common among Kenwood stereos and can be fixed with some relatively simple soldering.

However, I'm unsure how to remove the stereo from the car. I've searched this forum and other websites, and I've seen some instructions on removing stereos from older Tucsons or Santa Fes, but nothing on my vehicle. If anyone has any info or could point me in the right direction then that would be wonderful.

Thanks!!!
 
1 - 1 of 1 Posts
Top