Hyundai Forums banner
1 - 1 of 5 Posts

· Registered
17,570 Posts
C - Clamp over top of caliper with solid end at rear of piston bore, and threaded end against outboard pad... turn clamp down, caliper will compress as far as slides allow,,, then take large flat blade screwdriver, get between inboard pad friction material and rotor face and walk the piston the rest of the way in.. then remove caliper..

OR --- just remove caliper, place an old pad in the caliper, and use C-Clamp to walk piston home. :thumbsup:
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.