Search Results for ‘crank no start’

Hi guys I've got a 2010 i10 1.2 Automatic The engine cranks but no start. No error codes on diagnostic scanner. Battery is new. Car has spark. Coilpack was swapped into another car and works fine. Car has fuel pressure at the rail. Injector pulse is also present. Cam sensor replaced Crank speed...

Hi guys, looking for a bit of help. Got given my late uncles 2002 Elantra a week ago. Car has sat in a garage for about 2 years, only has 27,000km. I have tried to start it and it cranks but wont fire. I have put a new battery in, changed the ignition coil, spark plug leads & put new plugs in...

Will not start. Showing no codes. I have replaced - Crank position sensor, Cam position sensor, Purge valve unit, Lift pump in tank, High pressure fuel pump, Fuel pump relay. Car will start with a spray of gas in the air intake. Will shut off with removal of gas spray. At a complete loss. Any...

Hello, I hope you can help me. Engine cranks but does not start, ECM has no codes, fuel pump does not come alive when the key is in the ON position. The weird thing is, while the engine is a no-start, the CKPS has a constant reading of 3000 rpm, TPS of 51.76%, and ECT of 80 degrees celsius, and...

I have a 2012 Hyundai Sonata. The other day it completely died so I replaced the battery. The battery died quick so later that day I replaced the alternator. That lasted half the day. The car will now not start. Lights and radio all work but car won't start. Could that be a problem with starter...

Hi I have a 95 Accent 1.5 injection. so we recently decided to redo the engine, bearings rings, valve stem seals and headgasket, the car has been reassembled and the timing appears to be correct. the problem is that the car started but sounded like it was misfiring , the compression is fine...

So I’ve got a bit of a weird issue and honestly it’s got me and my mechanic stumped. So basically, where this starts, the bolt on the timing belt tensioner broke. On the side of the road, this was about three weeks after doing the timing belt so we believe that it was our error in over...

Hi I have a 2009 Hyundai Accent manual. I started having problems with it last summer it would crank forever and then start. It went on for a while and then just stopped. I have put a new battery in it, spark plugs, starter, and checked the timing. It still only cranks but won’t start. I can pop...

2014 Hyundai Tucson GLS 2.0 I was driving down the road when it went into limp mode. I immediately shut it off and realized there was a hole in the radiator that had caused the engine to slightly overheat and trip the (KDS)knock detection sensor. I replaced the radiator and battery because the...

Hello all 2005 Santa Fe 2.7 V6 unleaded 4WD auto. I've searched through most of the crank but no start posts on here and I couldn't find an answer to the specific problem that I have. The problem Engine will crank but not start. Will run fine on starting fluid with no knocks or funny noises...

Hi, My crankshaft came off whilst testing new timing belt (don’t ask how). Since then the engine turns over but there’s no ignition - won’t start. Ive double checked the timing alignment and tension etc. and confirmed the spark plugs have spark. Compression test proved 3 out of 4 cylinders have...

I am at lost here guys. Been having this problem for more than a month now. Let me get you up to pace of what happened. May 1st week - parked for 2 hrs then hard starting. Thought it might be the starter but after a min or 2 of keying, its good and no weird noises or anything Day after that -...

Apologies if this has been discussed before, but my Santa Fe 2013 DM 2.2 diesel has an annoying fault where sometimes, and there is no common factor as to when it happens, the engine will turn over but not start. When thus happens the engine is very 'lumpy". I turn it off and press the start...

For the last few weeks had a few stalls. One while driving and the rest while stopped or park. Was going to drive from Massachusetts to Florida last Friday and it stalled again while idling at the post office. It starts right up like it should. We took a different car down. The Hyundai was...

I'M WORKING ON A 2005 SANTA FE WITH A 3.5L V6 I HAVE INJECTOR PULSE BUT NO SPARK, I HAVE REPLACED BOTH CAM AND CRANK SENSORS WITH NEW ONES BUT I STILL HAVE NO SPARK CAN YOU PLEASE HELP ME?

2008 Santa Fe Limited 3.3l AWD with crank no start. Have fuel, spark, compression - suspect timing is off. Bought a Launch X431 bi-directional scanner. It shows codes that my older cheap reader does not. 3 codes set by the ABS/ESC system - all to do with bad communications: C1616...

Hi all, I'm from Alberta Canada and I have a 2011 Hyundai Santa Fe Limited AWD V6 that has been having intermittent no start issues for the past few months. It will crank all the time, but sometimes not fire. Sometimes you will just get in the car and it will not start completely at random...

Thanks to these excellent videos by ikilledbarbie, I was able to replace the belts on my 2008 Accent some years back. Recently, the car sounded as though a belt loosed and I ended up tightening the AC belt that got a bit loose. After tightening it, the car initially started, but the next day...

Hi! Recently (2019 december) I came across a starting issue with my 2003 Hyundai Accent CRDi hatchback. (194 000 km) As soon as the weather worsened, and the temps came below 0C, the car would need a lot of cranking to start the engine in the mornings. First I thought the battery is dying on me...

I’ve searched the forums with no luck. I have power, spark, power to the injectors, good fuel pump and a strong crank! And yet no start. Very frustrated. Thoughts?