Search Results for ‘camshaft sensor’

Hello, I am new to the group! I have a 2019 veloster 2.0. I bottomed out my car leaving a parking lot. Checked and everything looked good and had no damage. A few days later my check engine light came on about a week ago with a code reading P0017 crankshaft position, camshaft position...

Hi all, my 2010 Accent died while driving and will not start again. The code I get is P0342, a camshaft sensor fault. Here is what I have done so far: -Replaced camshaft sensor -Replaced battery -Replaced spark plugs -Replaced fuel pump -Tested battery (good) -Tested voltage at sensor...

I have a 2015 Sonata Sport that has about 70k miles on it (a little high, I know) and I'm at my wits end with this car. A little while ago, my check engine light came on and I ran the code. Code was P0340. I made an appointment immediately and had both camshaft sensors replaced. Less than 30 min...

Hello everyone! I get a P0340 error (Camshaft position sensor circuit malfunction). I am thinking of replacing the current CMP sensor with a new one. But I have difficulties locatiing the CMP sensor. Could someone indicate its position? I have changed the car's catalyst with the new one (when...

Guess it was posted wrong thread earlier......oh well here I go typing again. Let's hope I have proper thread, I put it under Sonata and year subforums this time. Last week my 2016 Sonata Sport with 115,000 miles shot off a P0010 intake camshaft position actuator Circuit / (bank1) code. I...

I went to a auto parts store and he read the codes on My 2010 Hyundai Sonata it had the code show up for the Camshaft sensor. He said buy it & replace it and it will fix it. Well I buy the part we put it on and now the car will not start at all. We hooked a reader up and it threw out the codes...

Hi, I recently bought a 2003 1.1l Getz with progressively worse starting problem.. I check the air filter, the sparks, clean the injectors, the idle valve, the map/iat sensor, replaced the spark plugs, and finally yesterday also the fuel filter; but continues not to start. So, I removed one...