this is a universal 8 inch 500 pound spring(its used to customised coil overs) i have installed it into my rear coils and now i have a 500 pound rear suspesnion that really is fully drag spec. the arse cannot dip and there is no weight transfer.
(IMG:
http://i283.photobucket.com/albums/kk281/Streetracing2008/0Photo-0006.jpg)
(IMG:
http://i283.photobucket.com/albums/kk281/Streetracing2008/Photo-0008-2.jpg)
It only takes 10 Minutes. you will need x2 jacks
1) jack up car
2) take wheel off
3) jack up rear suspension(the part that the rear shock is attached)
4) take out the one bolt that holds the shock in.
5) slolwy realease the 2nd jack
6) then take the springs out...
The scoupe Rubber bush/stoppers is actually designed to accomodate the large and small coil springs so this is really a direct fit...
This post has been edited by Schwitzer Turbo: Sep 6 2009, 01:19 AM