Welcome Guest ( Log In | Register )

 Hyundai-Forums.com > Hyundai Models > Accent Forum > 1G (1995-1999) Accent
      
Hyundai-Forums.com - The UNOFFICIAL Hyundai Community This site is NOT affiliated in any way with Hyundai or any of it's subsidiaries. Our goal is to provide Hyundai owners an information outlet - a means to communicate with other Hyundai owners. It is simply a community where fans and owners can get the right information for tuning, customization and general discussions on anything about Hyundai. You'll find the answer to almost any question about your Hyundai in this site. If not, simply join and ask! We have many willing expert members just waiting to answer your questions.
                        
 
 Reply to this topicStart new topic

Do you like Hyundai-Forums.com? Link to us and help spread the word about our forum. Thanks!
> A/t Problems, problems between 2nd/3rd
pilot
post Feb 28 2005, 07:42 PM
Post #1


Newbie


Group: Members
Posts: 2
Joined: 28-February 05
Member No.: 5,579
Status: Offline
Location: Reykjavik, Iceland
Drives: Hyundai Accent 1995
Hi, I have an Accent 1995 (USA type), when shifting up from 2nd to 3rd the engine spins and the process takes about 2-5seconds, I have 65000miles. Anyone knows what is wrong?
Also, I know now I should only use Hyundai oil but should I also change the a/t oil filter?
Best regards.
Go to the top of the page
 
+Reply
duke
post Feb 28 2005, 08:25 PM
Post #2


Community Advisor
*****

Group: Community Advisor
Posts: 1,830
Joined: 31-October 04
Member No.: 2,122
Status: Offline
Location: Holland Landing, Ontario, Canada
Drives: 2007 NF Sonata 2.4L
is the tranny cold or warm when this happen ???
Go to the top of the page
 
+Reply
pilot
post Mar 1 2005, 04:47 PM
Post #3


Newbie


Group: Members
Posts: 2
Joined: 28-February 05
Member No.: 5,579
Status: Offline
Location: Reykjavik, Iceland
Drives: Hyundai Accent 1995
QUOTE(duke @ Mar 1 2005, 01:25 AM)
is the tranny cold or warm when this happen ???
[right][snapback]7916[/snapback][/right]


It, doesnt matter, its same, hot or cold.
The only way to control this is by letting go of the gas pedal for a while ( a little frustrating when accelerating in heavy traffic) :crying:
Go to the top of the page
 
+Reply
duke
post Mar 1 2005, 08:21 PM
Post #4


Community Advisor
*****

Group: Community Advisor
Posts: 1,830
Joined: 31-October 04
Member No.: 2,122
Status: Offline
Location: Holland Landing, Ontario, Canada
Drives: 2007 NF Sonata 2.4L
have your Hyundai dealer check for fault codes in the ECM & TCM. Also, have him check the service data in both computers, especially the TPS sensor signal.
Go to the top of the page
 
+Reply
 
  Advanced Search
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:


Reply to this topicStart new topic
Get your Hyundai listed in the Garage Today, for FREE, to share with the world what you drive and what toys and modifications you have.

Collapse

> Similar Topics

  Topic Replies Topic Starter Views Last Action
No New Posts Attention: I30ownersclub Members
Important information/request
 21 dazzling_darryl 823 21st November 2008 - 03:07 AM
Last post by: Shambles
No New Posts Atoz Error Code Reader
 0 ericatwork 61 12th November 2008 - 04:39 AM
Last post by: ericatwork
No New Posts Atoz+ Driving Noise And Lower Mpg
Noise whilst driving and low mpg
 4 danieleonharper 205 9th November 2008 - 05:48 PM
Last post by: jimbobmelad
No New Posts At Shifting Problems, Error Codes
Vehicle shifts erratically
5 jbob 463 8th November 2008 - 01:15 PM
Last post by: LilBean
No New Posts Atoz Reverse Switch
 4 cossie123 645 31st October 2008 - 09:01 PM
Last post by: ChristopherR

 
23rd November 2008 - 07:13 AM
Hyundai-Forums.com is not affiliated with or endorsed by Hyundai Motor Company.
Powered By IP.Board 2.3.6 © 2008  IPS, Inc.