|
Hi there,
i also had the same following problem, but mine would go off at like 2:30 in the morning.
i just kinda did a dodgy quick fix, basically remove the horn cover, disconnect the 2 wires that go to it, once that's off, pull the cover off the horn cover, once you get that off you'll see a whole copper looking pad, you'll probably find that the 2 plates are to close together, all i did was seperate them and used electrical tape on one side of the plate around the edges, and along the rest of the plate except the middle bit which i just bent out more, then you just put the cover back over it, connect it back up and should work.
Hope that helps
|