hello i am currently selling/breaking my 1993 s-coupe turbo

i dont know execatly what to tell you the car is not in to bad a condition concidering it is 14 years old.

engine - well basically it is in pieces i blew the head gasket and took it apart the head has been skimmed and all values reseated professonally all parts are present apart from the turbo and mainfold which i...

Hi to all i'm new around, i bought a scoupe mkII 93' 1.5 12v non turbo, one week ago, it's not in driving condition right now, but as my projcet it will be default/' '' />
will post pics as the project will go along...

... first i had really...

Hello all,

I bought a Hyundai Scoupe about one month ago, and I have some little things to do on it in order to have a car as nice as possible.
I will post very soon some pictures of my Scoupe in the introduction forum or in this topic default/thumbsup.gif' 'thumbsup.gif'...

I've got a questing do I need to replace te bypass for the blow off valve or is it suppose to be anywhere else.

peace

Following on from the oil cooler post I've ordered one default/' '' /> it has the same sandwich plate as a honda prelude, civic 1.5 and 1.6's, etc

i12.ebayimg.com/05/i/07/7d/e6/88_1_b.JPG' />

A 25...

Hi Everyone,

First id like to say that yes I am a new member and this site is very well made, congrats to the people who take care of it default/' '' />.... Oh and I am a Canadian so d'ont hold that aginst me lollolol kidding

I have a 1993 scoupe LS, I...

Hi all i am new to this forum and was just wondering if any one here could help me find out what a "phase sensor" is.

i have checked the E.C.U. on my 1992 turbo scoupe and it shows a 3222 code which corrosponds to the phase sensor failure.

can any one tell me what a phase sensor is, where it is located, what it does, and is it a big fix. A photo would be much...

I picked up a 4g63t for my scoupe in arizona for $350 this weekend and i am intending to swap it in over the next couple months. i still need all the elantra mounts, 4g63 n/a clutch/pressure plate, a dsm turbo fuel pump and a new maf (the last jergoff who had the car took the honeycomb out). This will be slow going but my goal is to have it in by this month and running by feb.
...

hello all.

I'm having trouble finding a full suspension kit for my S Coupe.

So far i have found only 1 in europe.
Weitech - £350 from europerformance.com.

Is this a good make?

Does anyone know if any one else has suspension kits?

It.s driving me mad!

Thanks

Hey all been told my big end bearings are on the way out, makes a nice throaty noise when under load, so got to do that now, few questions

1) what actually needs doing, crank reground?, etc

2) Could i use a crank out of a non turbo 1.5 because i no someone who has a low mileage engine that hes getting rid off

3) do hyundai have all the parts required? Please list...

Hi guys which doner vehicle is best for the scoupe front disc upgrade

HI I NEED THE TRIM THAT GOES AROUND THE SPEEDO CLUSTER AND THE AIR VENTS IN BLACK AS ORIGNAL AND BEST CONDITION WITH NO MOUNTING TABS OR CLIPS BROKEN CAN ANYONE HELP? default/' '' />

Hi can someone tell me if a accent 1.5 crank will fit/work in my scoupe turbo?

cheers

chris

Hi...Hope somebody can help me, please..I need to repair or replace 2 parts underneath a 95 scoupe...someone called them control arms..but after checking places, they don't look like what I need. There are 2 metal pieces, running front to back, parallel but on each side..they have some badly rusted areas which I want to repair or replace. I believe running against one is the gas line...if...

Been offered a T28 off a 200sx would this fit ok? and what is required?

cheers
chris

Hi there.. i need to know the ecu reference of a 95' hyundai scoupe gt (turbo)
i know that starts 39110 - _ _ _ _ _ but i don´t know the rest.. if anyone knows.. default/tongue.gif' 'tongue.gif' />
and also where i can buy it on the net.. =) thanks in advance and sorry my poor...

Hi guys i am the owner of a mk1 and a mk2 scoupe. i have a spare mk2 turbo charged engine. How dificuilt will it be to place this engine in the mk1 body. I need the advise of others who have done it before .. tks

Is it wast of time, to change the throttle body on my Scoupe Turbo ?
Its look very small, so the idea is to fit a bigger one to gain hp.

Have any one in here tried something like that, with luck ??

cani put a Elantra 1.8L motor in my 95 Scoupe? if so what do i need?

Hi When i start my scoupe.. it starts with a fumble a vibration. Also if i stop at a stop light and i hit the brakes, the engine goes down to like 400 rpm and goes up back to 900 . Most of the times when i stop the engine vibrates, the steering wheel and i just did a oil change, i changed plugs almost a yr ago, i never changed gas filter, I changed plug wire the same time i changed spark plugs. I...

Is there any aftermarket catback/complete exhaust system available for the hyundai scoupe turbo?

What kind of a intercooler (size) do I need to look for to fit the scoupe easily/small modification?

How many ml. are injectors in Scoupe turbo 1994.
Some one says 195ml, but it sounds small i my ears ?

Regards from Denmark

See my Scoupe here :
http://bilgalleri.dk/html/gal_visbil.a...6446&ipc=361683

Hi:
As the new owner of a 95 Scoupe which came without an owners manual I am trying to sort out different features..Tried to download a manual at the site recommended here twice ..but the page would not come up. What I need to know is when do I drive in overdrive - with my previous non-Hyundai..it was recommended to always drive in o/d...is this the same with the scoupe? Also, there is a...

Out of interest because i bought mine off a m8, how much are these scoupes actually worth?

Just as the title says my MVTi is available. Not much needed to get it back on the road, New windscreen, MOT, Tax. Plus anything else it needs for MOT.

What I do know about the current condition is that it has the usual rust on the rear nearside wheel arch, some rust around the aerial hole. It might need a new exhaust or just the back box. The drivers seat has a slight tear due to...

I'm having a problem locating a wiring diagram for my 94 Scoupe stereo.
All the wires are a base colour with a different coloured stripe. ( eg. brown/white stripe etc etc)
Can't find anything that shows these colour codes
Would anyone have any info?
Thanks
Phil

hey dumb question but better safe than sorry...i need to use DOT 3 fluid for my clutch?

I have a 94 Scoupe non turbo

Hi.. i was just wondering if anyone knows where to order this frontbumper ..
its build for a scoupe not a custom. Got it from (http://hyundaiclubthailand.com)

539]

Does Scoupe -93 GT have the same timing belt as Mitsubishi Lancer 1.5i 12v?

I think I'm trying to put a wrong timing belt to my scoupe because I just can't get the marks right. The packet where the timing belt came, read also Mitsubishi 1.5i 12v, i'm wondering is this right?

Hi guys/girls, its been a while since i have been on here, sorry about that.

the scoupes had a few upgrades here and there since i was here last.

Now i heard a rumor that subaru wrx front bars fit pretty closely on our scoupes.

I remember reading something about it on here ages ago, but i cant find it.

Can anyone shed some light on it for me?

Hi,
1- does anyone know where I can get a obd 1 scaner for 1994 S-coupe?

Cheap of course-preferably new



2- Also proceedure for doing valve adjustment

I have an Eaton Compressor and a T25 Turbo I want to combine both...I have already done this, but think there must be a better way of doing this...

now the outflow of the compressor goes directly in the T25 inlet then it goes out from the T25 across a intercooler in to the throttle body... but I think that when I want about 1.2 bar boost that the compressor had not enough outflow for...

hey guys what size throttle body would be on a mk1 scoupe efi....
i want to put a bigger one on there but im not sure what size to go to...
thanks guys

Hi,

What do I need to increase the stock 0.5 bar to around 0.8/0.9 bar?
As faras I know, I only need a bleedvalve, blow off and a powerboost?
What about an intercooler, and wheren can I get one (Holland)? Anyone got more information or instructions/DIY on this one here?

hey all good news I've fixed my boosting problem it was the valve under the battery messing up. I want to start the power gains options now and I've searched the forum and i read a intercooler and oil cooler are a must, can anyone tell me what sandwich plate will fit on my car? from another car?



he seems to have a few but none for a hyundai

cheers

As most of you know, my scoupe was totaled back in October (on my 18'th birthday) by a guy in a BMW who ran a red light. Anyone, I've finally got a couple pictures to show.

Sorry that they are so blurry. All we had at the time was my dad's cell phone. I had left mine at the hospital with my girlfriend. There not so bad though...

Enjoy/Cry:
...

hey guys i would like to make my car faster just for street use..
the law here wont let me have turbo so i have to be n/a.
i would like to make th eengine stronger and more responsive if possible..
as i sayed im only using for street so i just need to beat cars mainly off the line..
my goal tho would be to beat my mates turbo marage..
its runing 5 psi on stock eveyr...

hey all, I've just bought a turbo scoupe and the gearbox is the only thing letting it down, 2nd and 3rd crunch, unless doing very slowey, can anyone tell me either what gearboxes fit from the Hyundai ranges? or where and how much it would cost to get it rebuilt?

cheers

chris

hey all sorry i'm such a looser and ask to many questions, but heres another one default/' '' />

my car has a boost problem now :S, when I'm accelerating the boost drops then comes back on then goes off etc until u hit about 4k then goes solid again

If anyone knows of a T25 turbo with Nissan fitments for sale in the U.K(CHEAPISH) and in good workin order, can u please let me know, thank you.

As the turbo is 1 of the 2 things i need to get my car on the road as my T15 is screwed.

The 2nd thing i need to get my car on the road is a new exhaust system, but instead of buyin a brand new standard 1, i am gunna put a full...

Hey i have a scoup 1.5mvi. I was wondering if i can fit the turbo off the mvti? what do i need to do?

hey all my sidelights will not turn off, even when the keys been taken out of the ignition, the stalk is set to off, any suggestions?

at the minute i have to pull the fuse/relay thing every time i park up.


cheers

chris

Hello everybody,

My Scoupe is stock and I would like to get more power to it. Only mod (that I know) is pipecross air filter.

My outlet is stock and the pipe from outlet to catalysator is 1.75" and from catalysator to end 2" with one Simons muffler.

I rememberd that Garrett T15 could go as far as 160bhp so and the the fuel up to 180bhp. So I think the...

Well, I did get a car over the Christmas break. It's a '98 Subaru Impreza RS 2.5 AWD.

I was also going to get a scoupe I found as well for only $800, but it was in HORRIBLE condition. So I didn't pick it up as well. For now I'm just going to enjoy my new, faster ride. The AWD feeling is awesome!!!!

Later guys, and sorry to let you down...

i have a 1992 scoupe, it is stock, i was driving down the interstate and it wouldnt go past 81 mph. is that the stock speed of the car? and how can i increase the speed.

Hi Guys,i'am looking for some information about strut bar to scoupe. Its true that strut bar from Toyota Tercel fit to Scoupe?