Join Date: Dec 2015
Location: South Carolina
Drives 2016 Elantra (Wife)
Drives 2016 Tucson Limited
Mentioned: 0 Post(s)
Quoted: 104 Post(s)
Catch Can Install on 1.6T
Material: 1/8" x 1" x 12"-14" aluminum plate from Lowes, M6-1.00 x 35mm bolt (1 1/2" but 1 1/4" would work), M6-1.00 hex nut and washer, 3/8" to 3/8" brass hose barb and 5 1/2' of fuel line.
Picture #1 shows the original mounting bracket and hole but I shortened it up to prevent to much flexing.
I removed the factory black bolt and replaced it with the M6-1.00 x 35mm bolt. I may paint it black in the future.
The zip tie holding the two catch can hoses to the radiator hose is slightly loose in case of expansion of the radiator hose.
Looks good to me and the can is lower than the PCV hose coming from the engine.
Last edited by HDHyundiaGuy; 06-14-2017 at 01:59 PM.